A reflow oven is a machine used primarily for reflow soldering of surface mount electronic components to printed circuit boards (PCB).

Precision lead free reflow oven

Drawer type desktop reflow oven

ZB series reflow furnace is mainly for the production and maintenance of SMT products such as desktop solder reflow equipment. The product uses high efficiency for infrared heating elements and distributed thermocouple temperature measurement device. Through the microcomputer’s precise control, the temperature of the reflow oven curve control can be more accurate, and the temperature of the reflow plane can be more uniform. ZB series reflow furnace is fully able to adapt to a variety of different alloys and lead-free solder reflow requirements. Its temperature curve precision can be adjusted; in addition, this kind of equipment also has automatic fault detection alarm and other function.

The ZB6245LS SMT machine has built-in WIN 7 system industrial control computers, eight sets of high resolution CCD industrial dual-camera system, and six heads simultaneous correction of online production stickers. The transmission mechanism is equipped with PANASONIC high resolution servo drive and motor, HIWIN linear slide rail and TBI ball screw rod, which can maintain long-term high precision and stable mounting.64 Pcs of 8*4 CL YAMAHA feeder, support TXT coordinate file import and edit, maximum 620*450 mm PCB, It is suitable for high precision mounting of components such as conventional resistance capacity, LED Lamp bead, IC, BGA and so on. It is suitable for automatic mass production.

ZB series placement machine main features:  Small volume, easy operate, run stable and price affordable. They can mount 0402, 0603, 0805, 1206, 1210, 3528, 5050, SOP and QFN etc chips precise. These machines can help to avoid the unstable performance because of manual mounting and reduce the rent cost, improve the product capacity at the same time.

ESD portiere is made of EVA material and can effectively restrain static charge and accelerate electrostatic discharge. Electrostatic charges in static sensitive area in air can be eliminated effectively to protect products and operators. It is easy to fix and change.

The ESD mat is used for a long time, has a good anti-acid, anti-alkali, chemical flux characteristics, and wear-resistant, easy to clean.
An ESD Mat or Antistatic Mat is a specially manufactured rubber or vinyl mat with conductive bottom layer to eliminate static electricity. These antistatic mats can be layed on floor or table top. These mats are specially manufactured with controlled low resistance. These ESD Mats need to be grounded with the help of thin metal sheet to be Layed on all four sides of the mat and then grounded using grounding coil. A resistor can also be used to slow down the discharge rate. An antistatic insulating mat without the copper layer below it would not provide any grounding.

Resistance of these ESD Mats is typically between 10⁵ to 10⁸ ohms between points on the mat and to ground. 

Soldering materials is made by, lead and many kinds of chemical active solvent, when soldering, toxic ingredients come out, which made many people getting headache, faint and so on. BK 493 smoke Absorber can remove toxin gas quickly and efficiently.

The antistatic stainless steel tweezers are made of high quality and high precision stainless steel. The tweezers have good flexibility and can effectively eliminate the electrostatic charge. These antistatic stainless steel tweezers are suitable for using in laboratories, hospitals, industries such as microelectronics, electronics, computers, watches and clean room project etc.